Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

HF 250-1 gas keeps flowing until unit is powered off

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • HF 250-1 gas keeps flowing until unit is powered off

    Gas solenoid already replaced. Any suggestions?

  • #2
    Stuck contacts in CR3 relay maybe

    Comment


    • #3
      Are you waiting the 15 seconds for the post flow timer to time out? 15 seconds is a long time when you're waiting.

      Comment


      • #4
        do you have a remote switch on your torch?and is it good

        Comment


        • #5
          Is the selector switch set to panel or switch?

          Comment


          • #6
            blow out the new valve with air and also blow out the hose too .i had a problem something like this and it was very fine dust that was in the hose.it doesn't take much to get a valve not to close.

            Comment


            • #7
              sound like the post flow timer is not timing or the relay is stuck like cruzer said.

              Comment

              Working...
              X
              Special Offers: See the latest Miller deals and promotions.