Announcement

Collapse
No announcement yet.

Ck rotary amp control for the Dynasty 200dx

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ck rotary amp control for the Dynasty 200dx

    Does anybody know where a guy can buy that belt type rotary amp control for this machine?

    also how many pins are on the connector for this machine

    just so i order the correct control

    thanks

  • #2
    I saw one in Air Liquide in Anchorage, Alaska yesterday afternoon. I believe it has 14 pins.

    Jerry in Anchorage

    Comment


    • #3
      6-pin

      i think it has a smaller connector with 5-6 pins on the dynasty 200dx

      Comment


      • #4
        Originally posted by Nextlevelrides View Post
        i think it has a smaller connector with 5-6 pins on the dynasty 200dx
        Nope you are thinking a Maxstar 150. The Dynasty uses the normal 14 pin miller connector. I know you can find those controls online too. If you put the part number of the one you want into google and then after you get your results click on shopping it will show you all the online retailers that sell it.

        -Dan
        Owner
        DW Metalworks LLC
        Miller Trailblazer 302
        Miller 8RC Feeder
        Miller Passport Plus
        Miller Dynasty 200 DX W/Coolmate 1
        Hobart Handler 135
        Hypertherm PowerMAX 30
        Smith O/A Torch Set
        Plus more tools then my wife will ever know about....

        Comment


        • #5
          Amptrols are made to fit each welder due to pin configuration and ohm rating. I called CK Worldwide but they would not sell direct. I purchased mine from Oxygen Service Co. Sauk Rapids, MN. 1-800-252-5494. When you purchase yours I recommend buying an extra "belt" as they do eventually wear out. These are the best amptrols I have used or seen. Good Luck.

          Comment

          Working...
          X