Announcement

Collapse
No announcement yet.

Trailblazer 301D - no exciter voltage

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Trailblazer 301D - no exciter voltage

    Hi-
    We have a Trailblazer 301D that is not putting out any voltage for welding or AC. Voltage checks shows that there is no exciter voltage coming from the power board. The power board is getting DC voltage however and both the power board and control boards work when swapped with an identical machine. Does anyone have any idea what else I can check?
    Thanks, Austin

  • #2
    Check fuse f1 and bridge SR2. If F1 is blown then SR2 has to be replaced

    Comment


    • #3
      Thanks for the reply. F1 is fine. SR2 was replaced all ready.But would this affect voltage on wires 131 to 134 going to the rings? I do not detect any voltage coming from the power board on these pins.

      Comment


      • #4
        Thanks for the reply. F1 is fine. SR2 was replaced all ready.But would this affect voltage on wires 131 to 134 going to the rings? I do not detect any voltage coming from the power board on these pins.



        Originally posted by cruizer View Post
        Check fuse f1 and bridge SR2. If F1 is blown then SR2 has to be replaced

        Comment


        • #5
          lets check to make sure you've got battery voltage comming in to run the darn thing first so test from RC15-2 to RC15-8

          So depending on your serial#, you should have say -13 VDC at RC15-1 to RC15-8 with a serial # less than LC241176 (Pos lead on RC15-1)

          Above that serial #, you should get zero volts
          Last edited by cruizer; 09-07-2010, 04:27 PM.

          Comment


          • #6
            May be as simple as a corroded R5 connector plug from the engine to the power board and front switch.. It happens....

            Comment


            • #7
              Traliblazer 301 no exciter voltage

              Took a while for me to get back on this, but the checks on RC15-2 to RC15-8 are 12 volts and on pins 1 to 8 are zero volts. The serial number is LE066615 so from what is stated below, it sounds like this is correct. Do you have any other ideas?

              Thanks

              Originally posted by cruizer View Post
              lets check to make sure you've got battery voltage comming in to run the darn thing first so test from RC15-2 to RC15-8

              So depending on your serial#, you should have say -13 VDC at RC15-1 to RC15-8 with a serial # less than LC241176 (Pos lead on RC15-1)

              Above that serial #, you should get zero volts

              Comment

              Working...
              X