Announcement

Collapse
No announcement yet.

Troubleshooting Miller Spectrum 2050

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Troubleshooting Miller Spectrum 2050

    Mabey you guys can help me with a problem im having with my plasma cutter. As the title states I have a Miller Spectrum 2050 and am having some problems.

    The problem is that it will not start an arc when I pull the trigger anymore. The power light is on, the ready light is on. I have checked the air pressure, its good the only thing that i can think of is that mabey the stinger is bad. One other thing is that when i used to power it up the fan would come on for a second or two and the stinger would let pressure out which it does not do anymore.

    Any help you could give would be great.


    Thanks

  • #2
    2050

    After you have verified the pressure is where it should be with air flowing - you can force this condition by turning current to zero - check for 400 volts on each of the two large electrolytic capacitors in the top of the machine. Be careful, there are lethal voltages here. weldersales

    Comment


    • #3
      Check the trigger first and its connection in side the case.
      Does the air flow in gas test?
      Loosen the retaining cap on the torch 1/4 turn and see if it fires.
      It maybe best to take it in. these are not easy machines to troubleshoot.
      Glenn 300 amp stick
      Millermatic 35
      L-tec plasma

      Comment

      Working...
      X