I bought the machine used a few months ago (it was fine at the time), but the hf seems to be going downhill.
I does the thing where if it doesn't strat, I rub the tungsten on the workpiece and then it will start. But now it sometimes takes a few tries.
So my questions are:
1) Is there a set of points inside with an arc gap I can clean/adjust? This was the case for my ole dialarc.
2) What's an HF board replacement cost? I am guessing this won't be a warranty job since I'm not the original owner...
Sorry to drag a beaten to deta subject back up, but I searched and couldn't find anything conclusive on these questions...