If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thanks AAMETALMASTER & Old Skool for the tip on 4043. I'm brand new to the forum. I sure do appreciate your feedback!
Here's a picture of what I'm trying to repair. Unfortunately I do not have the missing section of the case/motor mount that cracked off. I planning to clean up the break with a large holesaw to give me a clean circular edge, then TIG weld in a new circular piece of aluminum billet (6061) that will match the radius. Any opinions?