Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.


Announcement Module
No announcement yet.

Pipe Notcher

Page Title Module
Move Remove Collapse
Conversation Detail Module
  • Filter
  • Time
  • Show
Clear All
new posts

  • Pipe Notcher

    My friend has this pipe notcher.

    Good Luck,

  • #2
    The name seems like a misnomer as the cost is higher than most of the notchers I have used. 130$ per set of dies I can buy alot of hole saws or grinder wheels. I have an old scotchman notcher at work and it still requires deburring after the dies get some age on them.


    Special Offers: See the latest Miller deals and promotions.