If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The center section of that arm is a left and right hand threaded rod with a hex section in the middle. The two pieces to the outside from center are jamb nuts, then the ends are made with threaded bungs.
I could make them for you. PM me about it if you're interested.
XR Control and 30A Airco MED20 feeder Thermal Dynamics Cutmaster 81 Smith O/A rig And more machinery than you can shake a 7018 rod at
Thanks Hankl for uploading information, its beautifuly elaborated, i think for this you may need different parts which include, ball joints, perhaps tie rod ends, front torsion bar adjusters, replacement fuel line, hose clamps, replacement steering coupler, some wire or light rope, urethane bushings, special grease. different tools used for procedure, big wrenches ,big ball peen hammer,socket sets, high speed grinder etc there is a long list.