Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

help with an intake manifold

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • help with an intake manifold

    Hi folks,

    I ran into a little problem with a project and need some help.

    I took on a job to install a t-6 aluminum bung in the face of a Chevy BB intake manifold in the water passage just to the passenger side of the water pump bypass hose fitting.

    I used a Syncrowave 180SD on AC, maxed out, 3/32 pure tung nicely balled, 3/32 4043 rod wave was set biased to penetration. I prepped it well removing all the casting flash on the aluminum intake and filed the surface of the bung fitting. Cleaned it with acetone and preheated it with propane to about ~300 degrees F. I had a hard time getting it hotter as the manifold was sucking heat fast.

    I welded it and it looked ok...not great. Kind of dull grey..not shiney.

    Bottom line...it weeps. I have to fix it again..and I am wondering if my machine has enough power to work with this mass of aluminum. 180 amps is barely enough for 3/16 and the wall of the manifold is a good 1/4 inch ....not to mention the rest of the manifold is a BIG heat sink.

    should I have back gassed it when I did it to help with porosity... or is is porus from lack of heat and a cold weld?

    What do ya'll say?

    Thanks
    Mac.

  • #2
    Back gassing probably wouldn't have helped, think you need more heat. If the manifold is new, as in not contaminated with fuel and oil, and if your wife is
    a) away for the day
    b) left you for another guy
    c) out with the girls
    d) lets you do all the cooking

    you might try to repair it after placing it in the oven @ 500 deg for 30 minutes. Otherwise you need 250 amps +

    Comment


    • #3
      I was afraid that was the case. I shot it with the Fluke temp gun after preheating it and was amazed at the thermal conductivity of that manifold. It is used...and has had anti-freeze in it...

      Sounds like I better clean up the weld...and have him take it to a fellow with more amps...

      I don't think the wife will tolerate it going in the oven.

      Thanks
      Mac.

      Comment


      • #4
        Outdoor Cooking Anyone.??

        What about placing it in a gas outdoor grill.??
        Bob

        Comment

        Working...
        X
        Special Offers: See the latest Miller deals and promotions.