Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

distortion

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • distortion

    i wuold like to build a chassi from scratch, but i am concern that it will not come up straight, due from the heat when i weld. do you have any suggestions to avoid this problem?thanks in advance

  • #2
    A jig, carefull tacking sequences, rechecking square before every weld and lots of big clamps will help.

    I have built go-kart frames on the floor using chalk lines and cement blocks, weights and large items to hold stuff in place and they came out great(shifter cart style not just briggs and stratton stuff).

    It's all about where and when you weld each joint, you can counter one pull by welding in the opposing side. There's a lot of info out there both in books and on the net about jigging and welding to MINIMIZE distortion (you will never get rid of it all together)

    There's a really simple book called "the welders handbooK" that has a lot of info and touches on this subject a little. it's rather cheap book and covers the basics of just about every aspect of common welding

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.