If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
1/8 in. angle is a good choice. Make your first header on the car (or at least tack it). Then, use it to make the jig. Next, take a piece of angle and use it to bolt the flange to. Off of that make a frame that you can add more pieces of angle to in some of the long straight pieces of the primary tubing. It will look crazy without a header in the jig, but they work. The size angle depends on primary size. 2 in. is a good size for most. This is a very basic description I know, but it should help.
I guess I think a little different. I would fabricate the exhaust system on the engine/car, then start doing the power and tuning development on it. Lots of cutting up and changes until it works just right for the application. When everything it the way you like, then build a jig from the prototype. Just remember to let the fixture have a little "give" as to not stress the welds durring cooling. Have at it !
"Better Metalworking Through Research"
Miller Dynasty 300DX
Miller Dynasty 200DX
Miller Spectrum 375 extreme
Miller Millermatic Passport Miller Spot Welder Motor-Guard stud welder
Smith, Meco, Oxweld , Cronatron, Harris, Victor, National, Prest-o-weld, Prest-o-lite, Marquette, Century Aircraft, Craftsman, Goss, Uniweld, Purox, Linde, Eutectic, and Dillon welding torches from 1909 to Present. (58 total)