Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

Diesel truck guys (need a cummins 5.9 turbo)

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Diesel truck guys (need a cummins 5.9 turbo)

    Like it says, i'm looking for a Holset HX35, H1C, H1e or similar turbo taken from a dodge 5.9 cummins motor.

    The exhaust housing does not even need to be there, looking for the CHRA and compressor housing to be put in a smaller turbing housing for my 4 cyl eclipse motor. Trying to break into the 500 HP range with the motor i currently have in the machine shop and these turbos are what i want for at least getting me to 425-450 range, then i'll add the funny juice to break in the 500's

    These turbos were used on most all dodge cummins diesel motors from the mid 90's to mid 2000's model years.. on the 5.9 liter... Hopefully some of you have upgraded and sitll have the old one laying around and could use a few extra bucks for christmass

    PM me or reply here..

  • #2
    Check your private message's

    Comment

    Working...
    X
    Special Offers: See the latest Miller deals and promotions.