If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
just a gearhead, in the process of restorting my 70's chevelle, I found with pannel repair that everdur is best for tig wielding. It is a high silicon bronze rod, great for pannel repair, flows well, and grinds nicely. Don't use it on anything structural like frames, etc. On my mig wielder, I'm using and ER70S-6 mild steel .023 wire, which seems to work real well. So defenitly try using everdur for the tig. I've had great results.