Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums

The forum is currently undergoing maintenance and is in a 'read-only' mode for the time being. Sorry for the inconvenience.


  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Announcement Module
Collapse
No announcement yet.

outlaw streetstock

Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • outlaw streetstock

    i spent this past weekend in the shop while it was snowing and snowing and.... well you get the piont.

    mid 80's cutlass(metric frame) transforming into an outlaw streetstock. i may end up finishing it and running the series here in the northwest or maybe not.

    hope you all enjoy.

    steve

    http://s31.photobucket.com/albums/c372/nwmod39/outlaw/

  • #2
    made small progress this week. did some more torch gutting of the body as well as notch the stock frame rails for the main cage hoop to tie into bottom frame rail.

    also did my first bends on the pro tools 105 manual bender.

    hmmm. now all i nee is real power run out to the garage and maye i could start getting more serious about the cage work.

    steve

    Comment


    • #3
      Originally posted by nwmod39 View Post
      hmmm. now all i nee is real power run out to the garage and maye i could start getting more serious about the cage work.
      Heh. In the same boat.

      Comment

      Working...
      X
      Special Offers: See the latest Miller deals and promotions.