Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Conversation Between backhoe1 and rkrause

1 Visitor Messages

  1. I am new to this site Ihave a millermatic 252 . iam having a problem with the wire feed. There are no error codes on the digital display I ohmed out the trigger switch to the control board. Itis good I have engaged the trigger and checked for output voltage to the wire drive motor I have no out put. I have looked at the input voltage to the control card It is 91 volts. I do not have a schematic so i do not know what the actual reading should be. any advice or input.
Showing Visitor Messages 1 to 1 of 1

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 77

Welding Projects

Special Offers: See the latest Miller deals and promotions.