Welding Project - Converted Manual Tube Bender to Hydro

[Cebby]

Thought I'd throw up a link to my only welding proejct I've taken the time to document (and since it is ~almost~ Miller Blue, I thought I'd post up :p )

Cebby's JD2 Model 3 Homebrew Hydro Conversion (http://toolandfab.com/forum/forumdisplay.php?f=43)

Welded with my Millermatic 210.

[sstec]

Looks alot like mine....... :eek:
A lot easier to use and move around now.
I still need to add a retractable pipe holder to the rear on mine then paint.
sstec

[Paul Seaman]

SStec:
Very cool, BTW is that and Enerpak air over hydraulic power source your using.

[sstec]

Paul,
It is a ..........
ENERPAC
PUJ1201B
Hydraulic Pump, Voltage Rating 115 VAC, Reservoir Capacity 231 Cubic Inches, HP Rating 1/2 HP, Displacement @ 0-10,000psi 20 Cubic Inches per Minute.
Makes bending alot fast and less sweat. :D
sstec

[Paul Seaman]

Thanks:
I used one that had pneumatic/hydraulic that was cool but it was tricky to operate. The air operated model was sorta jerky, and that was why I asked Enerpac makes good stuff I think the one we were using was just worn out.

Thanks again,

[fun4now]

sweet. :cool:

and i dont even have a manual bender yet. :( aaaaa but when i get 1 that looks like the way to go. ;)

[aametalmaster]

sweet. :cool:

and i dont even have a manual bender yet. :( aaaaa but when i get 1 that looks like the way to go. ;)
Hey fun send me your email address and i will send you some drawings. If i can make one you can too :D ...Bob

[Paul Seaman]

BOB:
Nice BIG Block!!!!! :D

[aametalmaster]

1970 Ford 429CJ for my '64 T-Bolt clone. Got another one in my celler, but its not a CJ...Bob

[Steved]

Could you post your email?

If possible, I would like a copy of those plans as well.

Cheers,

Steve

[fun4now]

cool my e-mail is

bad2thebone@att.net

thanks :cool:

[aametalmaster]

aametalmaster@yahoo.com