Syncrowave 300 Hand Remote Control

[jb15780]

First posting ever.....

I have a Miller Syncrowave 300 and am in the market for a remote control amperage adjust for SMAW.

I have located a few RHC-3 Controls but my manual recommends the RHCS-3 Control. What I am in need of is some good information.

Does anyone know if these are interchangeable and if not who or where could I go to for that information?

Also if anyone has any leads on a good used RHCS-3 control feel free to let me know.

Thanks for any information!!!

[cruizer]

First posting ever.....

I have a Miller Syncrowave 300 and am in the market for a remote control amperage adjust for SMAW.

I have located a few RHC-3 Controls but my manual recommends the RHCS-3 Control. What I am in need of is some good information.

Does anyone know if these are interchangeable and if not who or where could I go to for that information?

Also if anyone has any leads on a good used RHCS-3 control feel free to let me know.

Thanks for any information!!!

I just converted a Lincoln pedal for one of these, it's just a standard 1K 2Watt pot with a 5 wire amphenol

So basically a standard RHC-14 will work, just have to change out the amphenol to a 5 pin.

[Jeffw5555]

Or you could do what I did....

I had bought an early Syncrowave 350 with the 5-pin amphenol header, but already had a 14 pin pedal and a 14 pin torch mounted control. I switched out the 5 pin header on the Syncrowave with a 14 pin one, instead of vice versa.

That way, my machine is compatible now with all newer pedals and hand controls.

[cruizer]

Yep, that would probably be easier,

Pin wires are the same from the 5 pin to the 14
A,B,C,D,E.

[Jeffw5555]

BTW, the best place to buy these 14 pin headers is Newark Electronics......