PDA

View Full Version : Need some advice!

mitchell beri
09-06-2008, 03:07 AM
I'm looking for a belt/ disk sander combo. I plan on upgrading from the small Craftsman setup i have already. Just need something that will do a good job for light fab work. Nothing too heavy. I've seen one at HF but i didn't know if it was worth buying.

Thanks. Mitch
monte55
09-06-2008, 06:31 AM
What size is yours................and what are you wanting to upgrade to. The
6x48 inch Craftsman units are fine. I have an older one that is cast and I like it. Some may consider it small. What will you use it for?
mitchell beri
09-06-2008, 04:28 PM
It's the smallest one craftsman makes. It's OK for little stuff but for anything decent size it's a little undersized. I want to upgrade to a larger one.

What size is yours................and what are you wanting to upgrade to. The
6x48 inch Craftsman units are fine. I have an older one that is cast and I like it. Some may consider it small. What will you use it for?