need dimensions for Spectrum 375 or 625

[H2o]

I am building a welding cart and do not own yet... a Spectrum 375 or 625 plasma cutter but am looking to do so soon.

But i want to plan for it in my welding cart. come someone give me the physical dimensions of both machines (height, width, depth) so that i can plan for it? Also, if there are any recommendations as to how you would install or mount on a cart.

thanks.

[MAC702]

http://www.millerwelds.com/pdf/spec_sheets/PC9-5.pdf

http://www.millerwelds.com/pdf/spec_sheets/PC9-1.pdf

[Sundown]

Mount it like this, it's just sitting on the cart ...

http://img.photobucket.com/albums/v180/Sundown2002/Weld%20Pictures/PlasmaCart016r.jpg

Thats a Spectrum 375 BTW ...

[Roospike]

Spectrum 625

Maybe these will help you out.

one pic shows how i mounted it , i made 4 small 90° brackets that mount to the body panel bolts of the unit and used self tap screws to the frame ..............She is solid.

I measured the MM210 and made the plasma top handle come out to the same height as the 210, i didnt build and pull handle on the plasma cart because i mounted the plasma cutter to the cart and use the handle on the plasma cutter to pull it around.

i put on a regulator and 2 point filter system and a M60 motor guard filter on the back .

http://i9.photobucket.com/albums/a97/Roospike/plasma/1a.jpg

http://i9.photobucket.com/albums/a97/Roospike/plasma/2a.jpg

http://i9.photobucket.com/albums/a97/Roospike/plasma/3a.jpg

http://i9.photobucket.com/albums/a97/Roospike/plasma/4a.jpg

http://i9.photobucket.com/albums/a97/Roospike/plasma/5a.jpg

http://i9.photobucket.com/albums/a97/Roospike/plasma/6a.jpg

[Roospike]

Spectrum 625

few more

[Roospike]

This pic show the size difference of the plasma cutters . The posted PDF files from Mac will give you the measurements on each .

When you look at plasma carts the size difference of the plasma cutter can and will change your cart needs .

When i built mine for the 625 i made it so i could mount a 625 ,2050 & 1000 if i ever wanted to go that route.



http://i9.photobucket.com/albums/a97/Roospike/plasma/millerplasma.jpg

[Rvannatta]

I am building a welding cart and do not own yet... a Spectrum 375 or 625 plasma cutter but am looking to do so soon.

But i want to plan for it in my welding cart. come someone give me the physical dimensions of both machines (height, width, depth) so that i can plan for it? Also, if there are any recommendations as to how you would install or mount on a cart.

thanks.

I suggest a 50 foot umbellical, and then you can do a lot less carting around.