Hands down... Lincoln 5P+

There are air vents in the bottom, both to provide combustion air and get rid of the ashes.

Thanks guys, Ill Try to put some pictures up...

Lincoln 5p+. I like to say there are two kinds of welders out there when it comes to 6010. Those like myself that do everything by themselves like...

Usually on dangerous equipment you lock it out. You guys must have a lock out procedure right?;)

Is it by any chance gas shielded stainless flux core? Take a look at the Lincoln Stainless Steel welding guide as well as their gas shielded...

shirt out. When I weld on something above or in a tight spot I either have a small squirt bottle handy or I spray down the exposed side to help with...

You will prob need a TWIC card. $137.50 an ID from the US Goverment...Bob

Like the Aceteyne shortage/price gouging. :mad: I did see a new mig welder and the door sticker read for welding SS use 75/25 gas. But i don't...

Hi Bigtow, Yes well I purchased the correct blade but it just did more damage than good. I then purchased a diamond tile saw blade for my 4 " angle...

Awesome job Chuck, I like your enthusiastic personality, Keep up the good work. It surely helps a lot of people get in to this awesome trade. Cheers...

Only one guy not guys. I'm well aware this is no carb hence why I asked where one would find it

Yes quite common, and for the idiot non diesel guys its best to lean out and rejet the carb, and change out the spark plugs

A friend of mine had the same problem and fix. Works great. Do you adjust the carb with a metric crescent wrench also. Lol

Cruizer is this a on going problem with the Pipepro , have you heard of anyone else with the same problem ? Thanks for the input !!

Hyundai. Ive also run Lincoln 5p which were terrible. They were difficult to restart and when you did most of the time the flux would pop off.

Sure there is. Just to the left of the aerial bearing and just above the drongle retroflector! (I'm sure that post was meant as humour as was this...

Gentleman diesels are injected there is no carb and no distributor.

Engine controller is damaged, Take it into your local Miller repair shop and have them change it out.

Please give us the name/designation of this wire, since this assertion by Airgas flies in the face of the metallurgy/chemistry of SS welding with...

How did that granet cut on your chop saw? I have some scraps from a remodel and I was thinking of adding it to the side "shelves" of my grill

The Pipepro 350 is diesel, With a Mitsubishi engine, So I'm clear sorry about that ! It's doing it when the engine is already hot And using it...