I would make up the receiver setup with a plate for floor mounting. Drill holes for four 3/8'' drop in anchors with female threads. You could even...

Very nice work !!

Sorry, arc yes.

Looks great. All the ones i ran just had a couple of rails for the bottom die to slide in...Bob

Are you setting the switch to power without setting the throttle to the slower POWER speed? There's a "Power Safety" micro switch activated by the...

Pins A, B, C, D & E are not grounded. Those are capacitors (C-16 thru 19) connected to them and ground. No, your machine doesn't use the K pin...

So you'll need to determine if the relay contacts are bad or the contactor coil is bad. Unit SN?

Would it not be advantageous to modify the insert, rather than the receiver? I'd worry that the receiver would be over shrunk.

Hey yes it is completely compatable

Hi, I'm trying to get my ducks in a row so that I can grind some tungsten. I have a spare grinder. I plan on replacing the existing wheel with...

I have been welding the sheets on and it was going great. i swear the machine gets warmed up and it runs better...and i dont think it is the heat in...

That is what I think too. I took it in last week and he hoped it would only take a week so we will see. My biggest worry is I only use it...

I think he means in the arc is having issues. Brendan can you specify as to which one it is?

I have seen guys in the city use those cargo boxes as a full size shop. Some of the smaller ones are 4 boxes stacked 2 high. Set about 20' apart and...

I use flap wheels for most of my aluminum.. then when I need a nice finish I use Walter blending wheels.. the ones with the Velcro pad. You can put...

Valves out of adjustment or maybe a dropped valve, broken keeper.

15 feet down is long way to fall, especially if you fall on your neck....being you're new to welding I suggest you do a search for coupons and get...

Ordered 2 separate pieces from miller 4 less- valve/solenoid- 035601 $65 fittings- 010296 $17 Miller tech laughed when I said those...

That's a nice stand, I've been wanting to make one for awhile now

Thank you. So, I guess I should remove ecoat to welding points and recoat with weldthrough, then when parts are clamped in place, remove weldthrough...

I have never had the problem myself, but how do you know that 25 cfh is getting to the nozzle? One thing to check is try the flow without...