Hey all, I live in Mcleod county here in Minnesota, and there are a lot of companies within half-hour of home that are hiring, paying anywhere from...

Mount two receiver tubes where the tow hooks mount so that you have two points of contact. Just thinking :cool:

I noticed this thread has not been updated recently. I just detected the same noise from my STH. Anyone have an answer to the question as to what...

Thank you Kpack. :)

1 problem with the front hitch is you have to cut a holebin the lower valance so that might be and issue The other thing I was thinking was how...

Great job

I think you need to find a different LWS. The TA186 comes with a series 26 air cooled torch. Both Diversions come with a series 17 air cooled...

Looks manufactured, great job. Is that a foster pump?

Mine are mono vision also, right eye for distance and left eye for close up. Didn't make my self clear, I need no corrective lenses. Dr. told me...

If you don't know where to get dies, swag4x4 has a bunch online on their website. They have some for angle iron. They are made to work in the harbor...

Kinky!

The biggest problem with the receiver tubes is the factory ones went "el cheapo" and use 3/16 wall thickness tube instead of the old Reese 1/4" wall...

Thanks cope, that's reassuring. The doctor at the eye clinic I go to has been doing it for years, I feel confident I'll be in good hands. :)

2 drivers is always better, less slippage. What size angle? and how tight of radius? Angle would be simple to roll with the right grooves cut into...

Just the opposite - had mine done about two years ago as well. No longer need glasses for my far vision problem, the lenses implanted had that...

Similar solution to what I suggested.:)

i figured id give you a bump to the top.your one **** of a friend! i wish i had friends as good as you. good luck finding some work.

So browsing this and other threads, I see different styles. Drive on 1 roll OR Drive on 2 rolls Removable top roll for removing material....

I had mine done a couple of years ago, and I have not had any problems. To the contrary, I no longer need reading glasses, so welding is actually...

What about a front receiver hitch? http://www.realtruck.com/hidden-hitch-front-end-receiver-hitches/ and then just find someone local to weld...

I made some calls today and the diversion 180 is going to be on rebate until August but the 165 is only till the end of the month which will give me...

Grind off the ecoat you can weld threw it with a little more heat but you get sloppy welds I have not found a weld threw primer that will leave nice...

Ahhh, serial #'s determine machine age, and wiring diagram, there are many

thanks pop, I had seen the article and one other but that's about it. I was kind of thinking about checking them out and I found out they will be...

it is going to be used at a dirt circle track for starting sprint cars and pushing disabled cars off the track