Miller Electric

Syncrowave 200

• 230 Volt unit
• Used for light to medium duty Aluminum and Steel TIG welding
• Spoilers, brake ductwork, light Alum brackets, 4130 material, dry sump tanks, radiators, seats, exhaust and header tubes, roll bars and body supports
• 5-200 Amps
• Can weld Aluminum up to 3/16” but well-suited for material .125” and less

Syncrowave 250 DX

• 200/230/460 Volt unit
• Used for TIG welding material .250” and less
• This unit is versatile to do any motorsports TIG fabrication work with an amperage range of 5 to 310 amps
• Great for spoilers, brake duct work, Alum brackets, dry sump tanks, radiators, seats, exhaust and header tubes, roll bars, suspension systems, 4130 material, body supports, valve covers and light Aluminum Head repair with preheat and Helium mix gas

Syncrowave 350 LX

• 200/230/460 Volt unit
• Used for TIG welding material .500” and less
• This unit is versatile to do any motorsports TIG fabrication work with an amperage range of 3 to 400 amps
• Comes with Pulser as standard equipment
• Great for spoilers, brake ductwork, Alum brackets, dry sump tanks, radiators, seats, exhaust and header tubes, roll bars, suspension systems, 4130 material, body supports, valve covers, Intake manifolds, Aluminum Head rework or repair

Dynasty 200 SD and DX

• 115V-460V input power along with its 45lb weight, makes this unit very powerful and portable.
• Used for TIG welding material .250 and less and is great for at track repairs as it draws very little primary power from your generator.
• Versatile enough to do any motorsports TIG fabrication work with an amperage range of 1 to 200 amps (1-110amps on 115V input power). Great for spoilers, brake duct work, aluminum brackets, dry sump tanks, radiators, seats, exhaust and header tubes, roll bars, suspension systems, 4130 material, body supports, and valve covers.
• Variable frequency and extended balance adjustments gives this unit an unbeatable arc.
• The Dynasty 300 is its big brother.

Dynasty 350

• 200/230/460 single or three phase unit
• Used to TIG weld anything!
• Great for material .750” and less with a low end of 5 amps
• Can independently change AC frequency and Balance of AC wave to give complete arc focus and control
• Inverter based unit draws little primary power and can be plugged into most low amperage MIG welder outlets giving this small, light weight welder mobility not normally enjoyed with larger units
• Also great for at-track welding needs
• This is the most advanced, versatile unit available
• Power savings allow two Dynasty machines to run where only one standard TIG unit could operate before

Maxstar 200 DX

• 120/200/230/400/440/460 single or three phase unit
• Small, lightweight, 37lb welder used for DC TIG or Stick welding with 1-200 amps of power
• Used mostly in the TIG process with chassis construction, lower control arms, upper A arms, mounting tabs, trailing arms/ truck arms, brake brackets, spindles, 4130 material, headers, exhaust tubes, oil pans and at-track repairs
• Can be used with or without water cooler