"Toe" Jack Milling Machine
I needed a simple jack to slip under a 2400 lb Milling Machine and lift up approximately 3-4 inches to allow the Milling Machine to be placed on a mobile carriage (another project).
Material consists of two pieces of .250 wall square tubing (2 and 2.5 inch)plus 1/2x2 inch bar. Base material is .250 and .50 inch pieces welded as shown.
Tools used were chop saw, MillerMatic 252 and hand grinder. Materials were .250 wall square tubing (2 and 2.5 inch). .250 plate and misc .500 x 2 steel bar. One 12 ton hyd jack