Welding Projects
Idea Gallery
Torch Holder Clamp
by EdZep
Message Board Post
Nov 8, 2008 @ 5:37 PM
I woud have to guess the capacity around 10 ton...
Safety is the primary concern on any project. Always use
tools and equipment in accordance with the manufacturer's instructions. For Miller products, refer to
your Owner's Manual for complete safety precautions and
procedures.
Miller provides the information in the "Welding Projects" section of this site for your information only. You are entirely responsible for your use of the information, your equipment, and the items you build. You are responsible for any injury to yourself or others and for any property damage. The information represents the opinions of individual welders, and does not necessarily reflect the opinions and views of Miller. The projects have not been engineered by Miller. Miller expressly disclaims any claims related to any content. For further information, see our Terms of Use.
Comments [3]
- Add Your Comment [255 Character Maximum]
I really do not understand the last post due to type o's maybe, but not withstanding, this is a great and simple portable idea! Maybe inner line the schdl 40 with PVC and what a winnner.
scott • Friday, August 15, 2008 @ 2:43 PMI LIKE IT. WHAT I DID WAS CUT A 5 INCH LENGH OF 3/4 PVC PIPE AND ATTACHED IT TO MY BENCH WITH 2 THIN PIPE WALL ATTACHEMENTS. SINCE IT IS PLASTIC, THERE IS ZERO POTENTIAL FOR CONDUCTION OF THE WANT. IT WORKS GREAT AND IS VERY CHEAP!
SAM • Tuesday, July 22, 2008 @ 8:01 PMnice what diameter is the pipe??
slickmcvic • Friday, April 25, 2008 @ 3:10 PM