Project: Adjustable Stand
When you need an extra hand to manage large workpieces, this simple adjustable stand is extremely helpful. It acts similar to a sawhorse for supporting materials.
Materials Needed
- (3) Legs, 1 inch (25.4 mm) Angle Iron cut to 23 inches (584.2 mm)
- Support, 1-1/4 inch (31.7 mm) Angle Iron cut to 10 inches (254 mm)
- (2) Ends, 1-1/4 inch (31.7 mm) Angle Iron cut to 4 inches (101.6 mm)
- Slide, 1 inch (25.4 mm) Pipe cut to 18 inches (457.2 mm)
- Trunk, 1-1/4 inch (31.7 mm) Pipe cut to 6 inches (152.4 mm)
- Rod, 1/4 inch (6.3 mm) Rod cut to 3 inches (76.2 mm)
- Hex Head Bolt, 1 inch (25.4 mm)
- Matching Hex Head Nut
- Paint
Examine dimensions and materials before you start. Most dimensions can be tailored to fit your exact needs. Other materials and thicknesses may also be substituted.
Tools Needed
- Grinder
- Drill and Drill Bits
- Chop Saw or Plasma Cutter, such as the Miller Spectrum 625
- MIG Welder, such as the Millermatic 180
- Safety Apparel
|
Click to Enlarge Image
|
||
| 1. | Cut materials to size. If necessary, use grinder to remove burrs and sharp edges from pieces. |
|
| 2. | Weld both end pieces to support. |
 
|
| 3. | Tack weld end of Slide to bottom edge of Support. |
|
| 4. | Drill a hole large enough to accommodate bolt 1 inch (25.4 mm) from one end of the Trunk. |
|
| 5. | Weld Hex Head Nut flush to the inside wall of the Trunk. |
|
| 6. |
Tack weld the three Legs to the Trunk about 1 inch (25.4 mm) below the Nut. Be sure they are evenly spaced around the Trunk and loacted at the proper angle to provide maximum stability. Then, complete the welds.
Variation: If additional support is desired for heavier weights, increase leg strength by welding a cross member between each of the Legs. |
 
|
| 7. | Weld the Rod to the head of Bolt. |
|
| 8. | Place Slide into Trunk. Insert the Bolt and adjust stand to desired height. |
|
| 9. | Brush welds smooth and paint if desired. | |
Safety is the primary concern on any project. Always use
tools and equipment in accordance with the manufacturer's instructions. For Miller products, refer to
your Owner's Manual for complete safety precautions and
procedures.
Miller provides the information in the "Welding Projects" section of this site for your information only. You are entirely responsible for your use of the information, your equipment, and the items you build. You are responsible for any injury to yourself or others and for any property damage. The information represents the opinions of individual welders, and does not necessarily reflect the opinions and views of Miller. The projects have not been engineered by Miller. Miller expressly disclaims any claims related to any content. For further information, see our Terms of Use.
